Honeywell H-S81-HS User Manual

70 H-S81-HS Installation & Operation Manual — P/N LS10114-000HI-E:A 2/24/2015
Parts of the H-S81-HS System I/O modules
Configuration
By using the ProS81 configuration program, the following parameters can be set for each virtual
channel:
The following parameters can be set for each module through the configuration program or directly
on the control panel in the operator cycle, access level 3:
Field Connections
This module does not feature any field connections, and therefore requires no terminations.
Function Type Mode
Operating mode Sensors NO
Activates/alarmed condition Sensors Non Latching
Type of indication Sensors Fire, Supervisory, Gas, Trouble, Hidden, Buzzer Only
Operating mode Actuators Continuous-Normally De-energized
Output type Actuators Normal
Enable/Disable status export to Hosts Sensors/Actuators No, TCP1, TCP2, RS232
Enable/Disable commands from Hosts
on the channel
Sensors/Actuators No, TCP1, TCP2, RS232
Parameter Mode
Release delay time 0-60 seconds
Reset inhibit time 1-30 minutes
Hold operating mode Mode-A / Mode-B
Figure 2.34 Fire Extinguishing System

Honeywell H-S81-HS Specifications

General

Brand	Honeywell
Model	H-S81-HS
Category	Control Panel
Language	English