Honeywell UDC2800 - Page 107

Function Prompt
Selections or Range of
Setting
Parameter Definition
functions was selected as the Input
Algorithm. See Note 2.
Calculated Low –999. To 9999.
Floating
(in engineering units)
Calculated Variable Low Scaling
Factor for Input Algorithm 1 —Used
only when either Summer, Input
Hi/Lo, or one of the General Math
functions was selected as the Input
Algorithm. See Note 2.
Algorithm 1 Input A Algorithm 1, Input A Selection will
represent one of the available
selections.
Input 1 Input 1
Input 2 Input 2
Output Output – Should not be used for
Three Position Step Control
applications)
Algorithm 1 Input B Algorithm 1, Input B Selection will
represent one of the available
selections.
Input 1 Input 1
Input 2 Input 2
Output
Output – Should not be used for
Three Position Step Control
applications)
Algorithm 1 Input C Algorithm 1, Input C Selection will
represent one of the available
selections.
None No Algorithm 1 Input C configured
Input 1 Input 1
Input 2 Input 2
Output Output – Should not be used for
Three Position Step Control
applications)
107
Chapter 4 - Configuration