Function
Prompt
Selections or
Range of Setting
Parameter Definition
None No Decimal Place—fixed, no auto-ranging
One Digit One Place
Two Digits Two Places
Three Digits Three Places
ATTENTION: Auto-ranging will occur for
selections of one, two or three decimal
places. For example, should the instrument
be configured for two decimal places and
the PV exceeds 99.99, then the display will
change to a single decimal place so that
values of 100.0 and above can be shown.
Temperature
Unit
This selection will affect the indication and
operation.
Deg Fahrenheit Degrees Fahrenheit – Degrees F Annunciator
lighted
Deg Centigrade Degrees Centigrade – Degrees C Annunciator
lighted
None No temperature annunciators lighted. Upper and
Lower Displays will show temperature in Degrees
Fahrenheit when inputs are configured for
Thermocouple or RTD types.
Input 2 Ratio Input 2 Ratio —This enables the Ratio for Input 2
to be set from the lower display. Input 2 must be
installed and enabled for this configuration to
operate.
Disable Disables setting Ratio 2 from front panel.
Enable Allows the Ratio for Input 2 to be set through the
keyboard.
Language English This selection designates the prompt language,
English.
TC
Diagnostics
Thermocouple Diagnostics — Enable or disable
Thermocouple diagnostic messages on the Lower
Display.
161
Chapter 4 - Configuration
To Next Page
Loading...
