Switching between setpoints
You can switch Local and Remote setpoints or between two Local
setpoints when configured.
ATTENTION: The Remote Setpoint value cannot be changed at
the keyboard.
Table 5-6: Procedure for Switching Between Setpoints
Step Operation Press Result
1 Select the
Setpoint
Function
key
To switch between the four Local Setpoints and/or
the Remote Setpoint.
ATTENTION: “KEY ERROR” will appear if:
l
the remote setpoint or additional local
setpoints are not configured as a
setpoint source.
l
you attempt to change the setpoint
while a setpoint ramp/program is
running.
l
you attempt to change the setpoint with
the setpoint select function key disabled.
l
while a setpoint ramp/program is not
terminated.
187
Chapter 5 - Monitoring and Operating the Controller
To Next Page
Loading...
