27
Installation Category (Overvoltage Category) : Category II (EN61010-1)
Energy-consuming equipment supplied from the fixed Installation.
Local level appliances, and Industrial Control Equipment
Pollution Degree: Pollution Degree 2. Normally non-conductive
pollution with occasional conductivity caused by condensation. (Ref.
IEC 664-1)
EMC Classification: Group 1, Class A, ISM Equipment (EN61326-1,
emissions), Industrial Equipment (EN61326-1, immunity)
Method of EMC Assessment: Technical File (TF)
Deviation from the installation conditions specified in this manual,
and the special conditions for CE conformity in Subsection 2.1, may
invalidate this product’s conformity with the Low Voltage and EMC
Directives.
ATTENTION: The emission limits of EN61326 are designed to
provide reasonable protection against harmful interference
when this equipment is operated in an industrial environment.
Operation of this equipment in a residential area may cause
harmful interference. This equipment generates, uses, and can
radiate radio frequency energy and may cause interference to
radio and television reception when the equipment is used
closer than 30 meters (98 feet) to the antenna(e). In special
cases, when highly susceptible apparatus is used in close
proximity, the user may have to employ additional mitigating
measures to further reduce the electromagnetic emissions of
this equipment.
WARNING: If this equipment is used in a manner not specified by
the manufacturer, the protection provided by the equipment may
be impaired.
Chapter 2 - Introduction
To Next Page
Loading...
Need help?
General
