Honeywell UDC2800 - Page 380

380
Parameter Description
Register Address
Access Description
Hex Decimal
Bit 0: 1 = Alarm 1 SP
1 State is High, or
Event is End; 0 =
State is Low, or
Event is Begin
Bit 1: 1 = Alarm 1 SP
2 State is High, or
Event is End; 0 =
State is Low, or
Event is Begin
Gain #2 (Prop Band #2 if
active)
0010 40017
R/W Signed 16 bit
integer, prescale *
10
Deadband 0011 40018
R/W Signed 16 bit
integer, prescale *
10
Reset #2 0012 40019
R/W Signed 16 bit
integer, prescale
*100
Rate #2 0013 40020
R/W Signed 16 bit
integer, prescale
*100
Cycle Time #2 0014 40021
R/W Signed 16 bit
integer, prescale *1
SP1; LSP #1 0015 40022
R/W Signed 16 bit
integer, prescale *
10 ( Note 1)
LSP #2 0016 40023
R/W Signed 16 bit
integer, prescale *
10 ( Note 1)
Alarm #2 SP #1 0017 40024
R/W Signed 16 bit
integer, prescale *
10
Alarm #2 SP #2 0018 40025
R/W Signed 16 bit
integer, prescale *
Chapter 12 - Standard Modbus Read, Write and Override Parameters