HP 8753E - Page 120

14. Perform a full 2-port error correction with isolation.
Note
When you are performing error-correction for a system that has
type-N test port connectors, the softkey menus label the sex of
the test port connector-not t$ @bration standard connector.
For example, the l&e1 ~tx#~~~~~~~~.~~ refers to the short that d
be connected to the female test port.
15. Save the results to disk. Name the lile “PORTl.”
16. Move the adapter to reference test port 1 and perform another full 2-port
error correction.
17. Save the results to disk. Name the file “PORT2.”
18. fiess Lcal) &$g ~~~~~~~~ ~~~~~~~~~~~~~.
.; ..,..:.,,./...... I .,........ . . . . . . . . . . . . . . . ../........~........... M . . . . . . . . . . . . . . . . . ;-, .,_, /;:..:..: . .... . . . . . . . . L ..,. . . . . . . . . . . . . . . . . . ..~.-...........~...............~.....~~.~~~.~.~.~.~~~..~~~.~.~.~.~~~~... i.
19. kom the disk directory, choose the We “PORTl”and press
.. _ ...... ::; :::: ~~,..: . . . . :.::.
~~~~~~~~::;~~~~~~.
~:.:.=,:.:.:.:.~,.:.:.:.:.:.:.:~~~~.~~,..~ ..__. ;....;&;. j _, _ _.,.... i in__ _
20. When this is complete, choose the fle “PORT2” and press
,.,.,.,............ _; .,./ ;..; i..,...,............i
~~~~~~~~~~~~~~~~.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
21. When complete, press J$EJE#W.
..~:::: i .._i..._
22. m enter the adapter delay, press ;~~~~~~~ L.llo] m (default for
i .: ::.. . . ..__... . . . . . . . . . . . . . As?=:: . . . . . . . . . . .i_>~>.~..s.x~.. :... .A.....<-
type-N adapter 1250-1777). The analyzer display will read 110 ps.
23. mess ‘~~~~~~ ~~~~~~~:~~~.:
* i _ i_ . . . . . . . . . . . . . . . . . ~.~.~.~.~ . . . . . . . .._................. _i -... i . . . . . . . . . . . . . . . . . . .
24. Save the results of the new cal set.
2-84 System Verification and
Performance Teets