HP 8753E - Page 600

set up the fractional-N frequency
range adjustment, 3-63
set up the fractional-N spur
avoidance and FM sideband
adjustment, 3-64
set up the high/Iow band transition
adjustments, 3-63
test external source mode frequency
range, 2-21
test frequency range and accuracy,
2-18
test minimum R channel level,
2-31
test port input noise floor level,
2-37
test port output frequency range
and accuracy, 2-18
test port output power accuracy,
2-24
test port output power range and
linearity, 2-27
troubleshoot, 41
troubleshoot accessories, 9-l
troubleshoot broadband power
problems, 7-39
troubleshoot digital control group,
6-l
troubleshoot receiver, 8-l
troubleshoot source group, 7-l
verify an analyzer system
automatically, 2-8
HP 8753E adhistments, 3-l
HP 8753E block diagram, 4-19
HP-IB addresses, 46
HP-IB cable,
l-4
HP-B3 Failures, 6-19
HP-IB mnemonic for service, 10-l
HP-IB service mnemonic defmitions,
10-48
HP-H3 system check, 46
I
IF ampiifier correction constants
adjustment, 3-16
IF GAIN AUTO, 10-21
IF GAIN OFF, lo-21
IF GAIN ON, lo-21
IF Step Cor., 19-13
improper calibration technique, 9-l
Init EEPROM, lo-14
INITlALIzATION FAILED, lo-53
initiaiize EEPROMs, 3-37
initial observations, 43
input noise floor level test, 2-37
inputs (A and B) check, 8-4
input traces check, 416
inspect cables, 6-16
inspect error terms, 9-3
inspection of test port connectors
and calibration devices, 9-3
inspect the accessories, 9-3
INSUFFICIENT MEMORY, PWR MTR
CAL OFF, lo-53
Inten DAC., 19-15
internal diagnostics, 10-2
inted diagnostic tests, 6-17
internal tests, W-3,10-7
INTERNAL TESTS, lo-4
inverter
digital control, 12-12
invoking tests remotely,
10-48
isolation (crosstaik, EXF and EXR),
11-14
K
key codes, 6-14
key
faihne identification, 6-14
keys in service menu, 10-l
kit re-certiiication, 2-7
kits
calibration kit 7 mm, 50131, l-3
calibration kit Type-N, 75Q, l-3
Index-12