HP 8753E - Page 68

HP 8753E
NETWORK ANALYZER
I Q m
, ‘I R CHANNEL
c
T
PORT1 PORT2
HP 8753E
NETWORK ANALYZER
ADAPTER
5on /7x-l
APC-3.5 (m)
MINIMUM
TO APCG7
LOSS PAD
R (
CABLE APC-7 24 INCH
* DIRECT CONNECTION
Figure 2-12. Minimum I1 Channel Level ‘I&t Setup
sg612e
4* mess CSca,e Ref, ~~~~“~~~~~~ 1-701 Ixil.
5. Press Ihnenul ~~~~~~ ~ ~.
-.-...-...._......... L~.:..<...AW.:>
. . . ..A .,.,.,. ,... . . . . . . . . ;,.; ,.,.,..
..::..:....:.
6- Press LMenu) !E&&fg @TJ @.
The analyzer displays the message CAUTION : NO IF FOUND : CHECK R INPUT
LEVEL.
7. Press @J to increase the test port power by 1 dBm.
8. If the analyzer displays a phase lock error message, continue increasing the
test port power until phase lock is achieved.
9. Write the test port power, that is displayed on the analyzer, on the
“Performance Test Record. n
10. Repeat steps 5 through 9 for the other CW frequencies listed in the
“Performance Test Record. n
2-32 Syetem Verification and
Performance Teete