Huawei Quidway S9300 - Interface Attributes; Table 5-16 Attributes of the 10 M;100 M Base-TX Ethernet Interface; Table 5-17 Attributes of the Console Interface

Name Quantity Description
MON interface 1 Environment monitoring control interface.
RS485 interface 1 Management interface of external PoE power
supplies.
BITS interface 2 The CLK1 and CLK2 interfaces on the MCU
map the BITS0 and BITS1 interfaces of the
clock board.
The BITS interfaces are connected to the
BITS device or connected to the BITS
interfaces of other products to synchronize the
time and clock.
NOTE
Currently, the S9300 does not support external PoE power supplies.
5.3.5 Interface Attributes
This section describes the attributes of the interfaces on the MCUA.
l Table 5-16 describes the attributes of the 10M/100M Base-TX Ethernet interface.
Table 5-16 Attributes of the 10M/100M Base-TX Ethernet interface
Attribute
Description
Connector type RJ45
Compliance
standard
IEEE 802.3
l Table 5-17 describes the attributes of the console interface.
Table 5-17 Attributes of the console interface
Attribute
Description
Connector type RJ45
Operation mode Full duplex Universal Asynchronous Receiver/Transmitter (UART)
Compliance
standard
RS-232
Data equipment
type
Data Circuit-terminating Equipment (DCE)
5 Boards
Quidway S9300 Terabit Routing Switch
Hardware Description
5-22 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 01 (2010-12-15)