Juniper BTI7800 Series User Manual

CHAPTER 7
BTI7800 Series Field Replaceable Units
(FRUs)
•
BTI7814 Field-Replaceable Units (FRUs) on page 179
•
BTI7802 Field-Replaceable Units (FRUs) on page 193
•
BTI7801 Field-Replaceable Units (FRUs) on page 199
BTI7814 Field-Replaceable Units (FRUs)
Field-replaceable units are pre-installed when the BTI7814 is delivered. This section
describes how to remove and replace the FRUs on the BTI7814.
WARNING: Use proper caution when working with the equipment. This chapter
might not cover every possible hazardous condition.
Safety Warnings
•
This equipment is intended to be installed and serviced by qualified personnel.
•
Be familiar with the safety guidelines described in the BTI7800 Series Hardware Overview
and Installation Guide.
•
Ensure the chassis is installed properly and secured onto the rack.
•
Ensure you have an unobstructed path to the chassis.
•
Avoid contact with rotating fan blades.
Electrical Warnings
CAUTION: Electrostatic Discharge (ESD) can damage module components,
causing complete or intermittent failures. ESD can occur when a module is
improperly handled.
To prevent ESD damage to a module, follow these guidelines:
179Copyright © 2019, Juniper Networks, Inc.

Juniper BTI7800 Series Specifications

General

Brand	Juniper
Model	BTI7800 Series
Category	Network Hardware
Language	English