Juniper EX2200 - Page 150

Table 35: Unsupported [edit interfaces interface-range] Configuration Statements for EX Series
Switches (continued)
HierarchyStatement
[edit interfaces interface-range]lsq-failure-options
[edit interfaces interface-range]multiservice-options
[edit interfaces interface-range]passive-monitor-mode
[edit interfaces interface-range]ppp-options
[edit interfaces interface-range]receive-bucket
[edit interfaces interface-range]satop-options
[edit interfaces interface-range]serial-options
[edit interfaces interface-range]stacked-vlan-tagging
[edit interfaces interface-range]transmit-bucket
[edit interfaces interface-range]vdsl-options
[edit interfaces interface-range ether-options]asynchronous-notification
[edit interfaces interface-range ether-options]ethernet-switch-profile
[edit interfaces interface-range ether-options]ieee-802-3az-eee
[edit interfaces interface-range ether-options]ignore-l3-incompletes
[edit interfaces interface-range ether-options]mpls
[edit interfaces interface-range ether-options]no-source-filtering
[edit interfaces interface-range ether-options]source-address-filter
[edit interfaces interface-range ether-options]source-filtering
[edit interfaces interface-range unit]accept-source-mac
[edit interfaces interface-range unit]allow-any-vci
[edit interfaces interface-range unit]atm-l2circuit-mode
[edit interfaces interface-range unit]atm-scheduler-map
[edit interfaces interface-range unit]cell-bundle-size
Copyright © 2015, Juniper Networks, Inc.130
Network Interfaces for EX4300 Switches