Juniper EX2200 - Page 169

recovery-timeout seconds;
storm-control profile-name;
vlan {
members (vlan-name | [vlan-names] | all;
}
}
family inet {
accounting {
destination-class-usage;
source-class-usage {
input;
output;
}
}
address ipv4-address {
arp ip-address (mac | multicast-mac) mac-address <publish>;
broadcast address;
preferred;
primary;
vrrp-group group-number {
(accept-data | no-accept-data);
advertise–interval seconds;
advertisements-thresholds number;
authentication-key key;
authentication-type authentication;
fast-interval milliseconds;
(preempt | no-preempt) {
hold-time seconds;
}
priority number;
track {
interface interface-name {
priority-cost number;
}
priority-hold-time seconds;
route ip-address/mask routing-instance instance-name priority-cost cost;
}
virtual-address [addresses];
vrrp-inherit-from {
active-group group-number;
active-interface interface-name;
}
}
}
filter {
input filter-name;
output filter-name;
}
mtu bytes;
no-neighbor-learn;
no-redirects;
primary;
rpf-check {
fail-filter filter-name;
mode {
loose;
149Copyright © 2015, Juniper Networks, Inc.
Chapter 3: Configuration Statements