Juniper EX2200 - Page 277

Cable status : Normal
Distance fault : 0 Meters
Polartiy swap : Normal
Skew time : 8 ns
MDI pair : 4-5
Cable status : Normal
Distance fault : 0 Meters
Polartiy swap : Normal
Skew time : 8 ns
MDI pair : 7-8
Cable status : Normal
Distance fault : 0 Meters
Polartiy swap : Normal
Skew time : 8 ns
Channel pair : 1
Pair swap : MDI
Channel pair : 2
Pair swap : MDI
Downshift : No Downshift
show diagnostics tdr interface ge-2/0/2 (Faulty Cable)
user@switch> show diagnostics tdr interface ge-2/0/2
Interface TDR detail:
Interface name : ge-2/0/2
Test status : Passed
Link status : Down
MDI Pair : 1-2
Cable status : 1-2
Distance fault : 2 Meters
Polartiy swap : N/A
Skew time : N/A
MDI Pair : 3-6
Cable status : Impedance Mismatch
Distance fault : 3 Meters
Polartiy swap : N/A
Skew time : N/A
MDI Pair : 4-5
Cable status : Impedance Mismatch
Distance fault : 3 Meters
Polartiy swap : N/A
Skew time : N/A
MDI Pair : 7-8
Cable status : Short on Pair-2
Distance fault : 3 Meters
Polartiy swap : N/A
Skew time : N/A
Channel pair : 1
Pair swap : N/A
Channel pair : 2
Pair swap : N/A
Downshift : N/A
show diagnostics tdr (All Supported Interfaces)
user@switch> show diagnostics tdr
Interface Test status Link status Cable status Max distance fault
ge-0/0/0 Not Started N/A N/A N/A
ge-0/0/1 Not Started N/A N/A N/A
ge-0/0/2 Started N/A N/A N/A
ge-0/0/3 Started N/A N/A N/A
257Copyright © 2015, Juniper Networks, Inc.
Chapter 5: Operational Commands