EasyManuals Logo

Juniper EX2200 Hardware Guide

Juniper EX2200
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #317 background imageLoading...
Page #317 background image
Table 50: show interfaces me0 Output Fields (continued)
Level of OutputField DescriptionField Name
Logical Interface
All levelsName of the logical interface.Logical interface
detail extensive noneIndex number of the logical interface, which reflects its initialization sequence.Index
detail extensive noneSNMP interface index number for the logical interface.SNMP ifIndex
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
All levelsInformation about the logical interface.Flags
All levelsEncapsulation on the logical interface.Encapsulation
detail extensiveNumber and rate of bytes and packets received (input) and transmitted (output)
on the specified interface.
Traffic statistics
detail extensiveIf IPv6 statistics tracking is enabled, number of IPv6 bytes and packets received
and transmitted on the logical interface.
IPv6 transit
statistics
extensiveNumber and rate of bytes and packets destined to and exiting from the switch.Local statistics
detail extensive noneProtocol family.Protocol
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
detail extensiveRouting table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Route Table
detail extensiveInformation about protocol family flags.Flags
extensiveIngress filter name.Input Filter
extensiveEgress filter name.Output Filter
detail extensive noneInformation about the management interface addresses.Addresses
detail extensive noneInformation about the address flags.Flags
detail extensive noneIP address of the remote side of the connection.Destination
detail extensive noneIP address of the logical interface.Local
detail extensive noneBroadcast address of the logical interface.Broadcast
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
297Copyright © 2015, Juniper Networks, Inc.
Chapter 5: Operational Commands

Table of Contents

Other manuals for Juniper EX2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX2200 and is the answer not in the manual?

Juniper EX2200 Specifications

General IconGeneral
Throughput77 Mpps
MAC address table8000 entries
Jumbo frames supportYes
Number of VLANs1024
Networking standards-
Switch typeManaged
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports quantity48
StackableNo
Product colorBlack
Power consumption (typical)100 W
Operating altitude0 - 3048 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth254 mm
Width441 mm
Height43 mm
Weight3600 g

Related product manuals