EasyManuals Logo

Juniper EX2200 Hardware Guide

Juniper EX2200
354 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #336 background imageLoading...
Page #336 background image
Table 52: show interfaces xe- Output Fields (continued)
Level of OutputField DescriptionField Name
detail
extensive
none
Route table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Route Table
detail
extensive
Names of any input filters applied to this interface.Input Filters
detail
extensive
Names of any output filters applied to this interface.Output Filters
detail
extensive
Information about protocol family flags.
If unicast reverse-path forwarding (RPF) is explicitly configured on the specified
interface, the uRPF flag is displayed. If unicast RPF was configured on a different
interface (and therefore is enabled on all switch interfaces) but was not explicitly
configured on the specified interface, the uRPF flag is not displayed even though
unicast RPF is enabled.
Flags
detail
extensive
none
Information about the address flags.Addresses, Flags
briefProtocol family configured on the logical interface. If the protocol is inet, the IP
address of the interface is also displayed.
protocol-family
detail
extensive
none
Information about the address flags.Flags
detail
extensive
none
IP address of the remote side of the connection.Destination
detail
extensive
none
IP address of the logical interface.Local
detail
extensive
none
Broadcast address of the logical interlace.Broadcast
detail
extensive
Unique number for use by Juniper Networks technical support only.Generation
Sample Output
show interfaces xe-4/1/0
user@switch show interfaces xe-4/1/0
Physical interface: xe-4/1/0, Enabled, Physical link is Up
Interface index: 387, SNMP ifIndex: 369
Copyright © 2015, Juniper Networks, Inc.316
Network Interfaces for EX4300 Switches

Table of Contents

Other manuals for Juniper EX2200

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper EX2200 and is the answer not in the manual?

Juniper EX2200 Specifications

General IconGeneral
Throughput77 Mpps
MAC address table8000 entries
Jumbo frames supportYes
Number of VLANs1024
Networking standards-
Switch typeManaged
SFP module slots quantity4
Installed SFP modules quantity0
Basic switching RJ-45 Ethernet ports quantity48
StackableNo
Product colorBlack
Power consumption (typical)100 W
Operating altitude0 - 3048 m
Non-operating altitude0 - 4877 m
Storage temperature (T-T)-40 - 70 °C
Operating temperature (T-T)0 - 45 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)10 - 85 %
Weight and Dimensions IconWeight and Dimensions
Depth254 mm
Width441 mm
Height43 mm
Weight3600 g

Related product manuals