Juniper EX2200 Hardware Guide

Table 13: Port Role Configuration Summary (continued)
CLI CommandsConfiguration Description
set protocols rstp interface interface edge
Set RSTP protocol with edge option.
set protocols rstp interface interface disable
RSTP protocol is disabled if redundant trunk groups
are configured.
Routed Uplink Port Role
set interfaces interface apply-macro juniper-port-profile
Routed Uplink
Set the port role to Routed Uplink.
set interfaces interfaceunit 0 family inet address
ipaddress
Set port family to inet.
Set IP address on the port.
set class-of-service interfaces interfacescheduler-map
juniper-port-profile-map
set class-of-service interfaces interface unit 0
classifiers ieee-802.1 juniper_ieee_classifier
set class-of-service interfaces interfaceunit 0 classifiers
dscp juniper-dscp-classifier
Set class-of-service parameters
SCHEDULER_MAP=juniper-port-profile-map
IEEE_CLASSIFIER=juniper-ieee-classifier
DSCP_CLASSIFIER=juniper-dscp-classifier
Refer Table 14 on page 44 for details.Set CoS configuration
Layer 2 Uplink Port Role
set interfaces interface apply-macro juniper-port-profile
Layer2 Uplink
Set the port role to Layer 2 Uplink.
set interfaces interface unit 0 family ethernet-switching
port-mode trunk
Set port family to ethernet-switching
Set port mode to trunk.
set interfaces interface unit 0 family ethernet-switching
native-vlan-id vlan-name
Set Native VLAN name.
set interfaces interface unit 0 family ethernet-switching
vlan members vlan-members
Set the port as part of all valid VLANs; ”valid" refers
to all VLANs except native VLAN and voice VLANs.
set ethernet-switching-options secure-access-port
dhcp-trusted
Set port security parameter.
set protocols rstp interface interface mode point-to-point
Set RSTP protocol with point-to-point option.
set protocols rstp interface interface disable
Disable RSTP if redundant trunk groups are
configured.
set class-of-service interfaces interfacescheduler-map
juniper-port-profile-map
set class-of-service interfaces interface unit 0
classifiers ieee-802.1 juniper_ieee_classifier
set class-of-service interfaces interfaceunit 0 classifiers
dscp juniper-dscp-classifier
Set class-of-service parameters.
SCHEDULER_MAP=juniper-port-profile-map
IEEE_CLASSIFIER=juniper_ieee_classifier
DSCP_CLASSIFIER=juniper_dscp_classifier
43Copyright © 2015, Juniper Networks, Inc.
Chapter 2: Configuration Tasks

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g