Juniper EX2200 Hardware Guide

Table 13: Port Role Configuration Summary (continued)
CLI CommandsConfiguration Description
set interfaces interface unit 0 family ethernet-switching
vlan members vlan-members
Set VLAN if new VLAN is specified.
set ethernet-switching-options secure-access-port vlan
MacTest arp-inspection
Set port security parameters.
set protocols rstp interface interface edge
Set RSTP protocol with edge option.
set protocols rstp interface interface disable
RSTP protocol is disabled if redundant trunk groups
are configured.
Desktop and Phone Port Role
set interfaces interfaceapply-macro juniper-port-profile
Desktop and Phone
Set the port role to desktop and phone.
set vlans vlan-namevlan-id vlan id
Set data VLAN if new VLAN is specified.
Set voice VLAN if new voice VLAN is specified.
set interfaces interfaceunit 0 family ethernet-switching
port-mode access
Set port family to ethernet-switching.
Set Port Mode to access.
set interfaces interface unit 0 family ethernet-switching
vlan members vlan-members
Set data VLAN on port stanza.
set ethernet-switching-options secure-access-port vlan
MacTest arp-inspection
Set port security parameters.
set ethernet-switching-options voip interface interface.0
vlan vlan vlan name
Set VOIP VLAN.
set class-of-service interfaces interfacescheduler-map
juniper-port-profile-map
set class-of-service interfaces interface unit 0
classifiers ieee-802.1 juniper_ieee_classifier
set class-of-service interfaces interfaceunit 0 classifiers
dscp juniper-dscp-classifier
Set class of service parameters
SCHEDULER_MAP=juniper-port-profile-map
IEEE_CLASSIFIER=juniper-ieee-classifier
DSCP_CLASSIFIER=juniper-dscp-classifier
Refer Table 14 on page 44 for details.Set CoS Configuration
Wireless Access Point Port Role
set interfaces interface apply-macro juniper-port-profile
Wireless Access Point
Set the port role to wireless access point.
set vlans vlan namevlan-id vlan-id
Set VLAN on VLANs stanza.
set interfaces interface unit 0 family ethernet-switching
port-mode access
Set port family to ethernet-ewitching
Set port mode to Access.
set interfaces interface unit 0 family ethernet-switching
vlan members vlan-members
Set VLAN on port stanza.
Copyright © 2015, Juniper Networks, Inc.42
Network Interfaces for EX4300 Switches

Juniper EX2200 Specifications

General

Throughput	77 Mpps
MAC address table	8000 entries
Jumbo frames support	Yes
Number of VLANs	1024
Networking standards	-
Switch type	Managed
SFP module slots quantity	4
Installed SFP modules quantity	0
Basic switching RJ-45 Ethernet ports quantity	48
Stackable	No
Product color	Black
Power consumption (typical)	100 W
Operating altitude	0 - 3048 m
Non-operating altitude	0 - 4877 m
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Storage relative humidity (H-H)	0 - 95 %
Operating relative humidity (H-H)	10 - 85 %

Weight and Dimensions

Depth	254 mm
Width	441 mm
Height	43 mm
Weight	3600 g