An OK response verifies that the modem can communicate successfully with the COM
port on the management device.
6. To configure the modem to answer a call on the first ring, type ATS0=1.
7. To configure the modem to accept modem control DTR signals, type AT&D1.
8. To disable flow control, type AT&K0.
9. To save modem settings, type AT&W.
Related
Documentation
• Connecting to the SRX650 Services Gateway from the CLI Remotely on page 106
• Connecting the Modem to the Console Port on the SRX650 Services Gateway on
page 86
• Connecting the CLI at the User End for the SRX650 Services Gateway on page 87
89Copyright © 2018, Juniper Networks, Inc.
Chapter 17: Connecting the SRX650 Services Gateway to External Devices
To Next Page
Loading...
