6. Remove the clear plastic cover protecting the terminal studs on the faceplate.
7. Attach the power cable to the DC power source.
8. Verify that the DC source power cabling is correct. If the power cable is correctly
installed and the power supply is functioning normally, the POWER LED on the front
panel lights green steadily.
Related
Documentation
• Required Tools and Parts for Replacing Hardware Components on the SRX650 Services
Gateway on page 141
• Removing a DC Power Supply on the SRX650 Services Gateway on page 147
• Installing a DC Power Supply on the SRX650 Services Gateway on page 78
149Copyright © 2018, Juniper Networks, Inc.
Chapter 24: Replacing Power System Components
To Next Page
