Keithley 2700 - Page 497

Auto scan 7-21
Basic scan 7-22
Buffer 7-22
Configuration 7-10
dB 5-21
Digital outputs 9-12
Digits 4-6
Examples 7-33
External trigger scan example 7-33
Filter 4-19
Fundamentals 7-2
Limits 9-4
Manual/external trigger scan 7-23
Math 5-12
Monitor scan 7-36
Monitor scan (analog trigger) 7-24
Operation 7-22
Process 7-4
Range 4-3
Rate and bandwidth 4-10
Ratio and channel average 5-18
Relative 5-3
Remote programming 7-26
Remote programming example 7-32
Reset 7-13
Resume scan after power-up 7-21
Sequential and non-sequential 7-3
Simple 1-32, 7-13
SCPI commands G-10
SCPI commands see FORMat commands, SCPI
reference tables, SCPI signal oriented
measurement commands, and SYSTem
commands
SCPI reference tables 15-1
CALCulate commmand summary 15-3
DISPlay command summary 15-6
FORMat command summary 15-6
ROUTe command summary 15-7
SENSe command summary 15-9
STATus command summary 15-20
SYSTem command summary 15-21
TRACe command summary 15-24
Trigger command summary 15-25
UNIT command summary 15-26
SCPI signal oriented measurement commands
13-1
CONFigure:<function> [<rang>], [<res>],
[<clist>]
13-4
FETCh? 13-6
READ? 13-7
Serial polling and SRQ 11-8
Settings
Default 1-20, 1-22
Setups 1-20
Commands 1-25
Remote programming 1-25
Restoring 1-21
Saving 1-21, 7-21
Shielding 3-15, 3-22, E-8
Signal handshaking 10-19
Signal processing sequence D-2
Slot numbering 2-5
Software 1-6
Source mode
Logic control 9-10
SPE, SPD (serial polling) 11-8
Specifications A-1
Speed
Setting measurement speed 4-9
vs. noise characteristics 4-8
Standard event status 11-12
Status and error messages C-1
Status byte and service request (SRQ) 11-6
Commands 11-9
Status indicators
GPIB 10-10
Status structure 11-1
Overview 11-2
STEP 7-7, 7-17
Operation overview 7-7
Switching modules 1-3, 1-7
Cables and connector kits 1-5
Closing and opening channels 1-29, 2-1
Connections 2-3
Identifying installed 1-10, 2-28
Installation 2-3
Model 7700 2-34
Queries 2-31
Viewing closed channels 2-28
System channel
Control commands 2-12
Controlling 2-9
Operation 1-29, 2-6
SYSTem commands 14-8
Summary 15-21
SYSTem:BEEPer[:STATe] <b> 14-9
SYSTem:KEY <NRf> 14-8
SYSTem:PRESet 14-8
SYSTem:VERSion 14-8
T
Temperature
Best temperature sensor 3-33
Equations F-1
Measurements see Temperature measure-
ments
Temperature measurements 3-33