Keysight B2961A/B2962A SCPI Command Reference, Edition 6 2- 3
Subsystem Command Summary
NOTE The following subsystem commands are classified under the TRIGger subsystem
because they are used for trigger operations.
• ABORt
•ARM
•IDLE
•INITiate
•TRIGger
For examples of the source output and measurement operation, see Figure 2-9. Also
see Figures 2-8 and 2-10 for using the trigger commands. For these commands, see
Table 2-9.
NOTE For details on numeric suffixes [c], [d], [h], [i], [j], and [n], see “Numeric Suffix” on
page 1-8.
To Next Page
Loading...
