Normal Annunciations
Normal annunciations are shown in GREEN and advise a normal operating
condition.
Annunciation
Window Text
Annunciation Description
ENG INLET NRM
Advises the pilot that the inertial separator is placed in the normal
position.
Advisory Annunciations
Advisory annunciations are shown in WHITE and advise the pilot of a system
function.
Annunciation
Window Text
Annunciation Description
AUX PUMP ON
Advises the pilot that the auxiliary fuel pump in ON.
AUX BUS ON*
Advises the pilot that the auxiliary bus is active.
STARTER ON
Advises the pilot that the starter switch is placed in the HI START or
LO/MOTOR position and power is being supplied to the starter.
IGNITION ON
Advises the pilot that the ignition switch is in the ON position.
BETA
Advises the pilot that the propeller system is in BETA mode.
ENG INLET BP
Advises the pilot that the inertial separator is placed in the bypass
position.
BLEED AIR ON*
Advises the pilot that the bleed air heat is activated. The pilot action
is to ensure the engine power is set below the limits specied in
“Section 5” of this manual.
FUEL OFF L
Advises the pilot that the left fuel selector is in the OFF position. The
pilot action is to ensure the valve is returned to the ON position prior
to takeoff or landing.
FUEL OFF R
Advises the pilot that the right fuel selector is in the OFF position.
The pilot action is to ensure the valve is returned to the ON position
prior to takeoff or landing.
ENG INLET BP
Advises the pilot that the Engine Inlet is in the BYPASS position.
AIR COND INH**
Advises the pilot that the Air Conditioning system has been inhibited
(turned off).
* If your airplane is equipped with GDU software version 12.03 or higher, advisory
annunciations for AUX BUS ON and BLEED AIR ON will NOT be shown.
** AIR COND INH annunciation will only appear on airplanes equipped with GDU
software version 12.03 or higher AND an Air Conditioning system.
To Next Page
Loading...
Need help?
General