Kodiak 100 Series - Passenger Seats Removal and Installation

Pilot’s Operating Handbook
7-67
DO NOT USE FOR FLIGHT OPERATIONS
Section 7
AIRPLANE & SYSTEMS DESCRIPTIONS
100 SERIES
Systems
PASSENGER SEATS REMOVAL AND INSTALLATION
Passenger Seat Removal:
1. Using a at head screw driver, locate and loosen the cable tensioners (x2)
by rotating counterclockwise 3/4 turn.
2. Using a at head screw driver, locate and unlock the seat foot by rotating it
90 degrees, as shown below.
3. Once the feet are unlocked, slide the seat AFT 1/2 of a track notch to allow
the feet to exit the track. Once moved AFT, lift up the seat and the seat will
clear the rails. The seat is now ready for storage. Seats will fold for ease of
storage.
4. Update the aircraft weight and balance for ight, using the procedures
dened in “Section 6” of this manual.
3/4 turn
2 Locations
Turn 90
o
2 Locations
AFT 1/2 Seat Track
Uncontrolled if printed