Malfunctions - Causes and Remedies
335
Pos: 46.34 /BA/Störunge n - Ursachen und Behebung/ Großpackenpressen/S törungen-Ursac hen-Behebung Doppelkn oter T8 @ 25\mod_1242041192 745_78.doc @ 249642
No
.
Malfunction Cause and/or remedy
9 No knot present, neither on the upper nor
on the lower twine strand.
7
BPXC0270
6
9.1
Cause:
Twine bar is not activated.
Remedy:
Check the twine bar mechanism and its settings (refer to
chapter Settings "Setting the twine bar (double knotter)”).
9.2
Cause:
Damaged knotter tongue.
Remedy:
Replace the knotter tongue (1).
9.3
Cause:
Insufficient tension on the knotter tongue.
Remedy:
Increase the tension on the knotter tongue (1).
To do this:
• Tighten nut (2) on the leaf spring (3) by about 60°
(cf. malfunction no. 2.3)
9.4
Cause:
Twine retainer springs too tight
or
Twine strands are cut through in the twine retainer
Remedy:
Loosen the twine retainer spring setting. To do this:
• Undo the counter nut (4)
• Ensure weaker pre-tensioning of the twine retainer
spring (5) with the screw (6) (approx. half a turn)
Remove accumulations of dirt or chaff under the twine
retainer springs (5).
9.5
Cause:
The knotter hook is not turning.
Remedy:
Exchange the pin (6) of the knotter hook drive wheel (7).
Pos: 46.35 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
