Malfunctions - Causes and Remedies
336
Pos: 46.36 /BA/Störunge n - Ursachen und Behebung/ Großpackenpressen/S törungen-Ursac hen-Behebung Doppelkn oter T9 @ 25\mod_1242042248 604_78.doc @ 249667
No
.
Malfunction Cause and/or remedy
10 Knot ends too short. The knot often gets
wound up (generally the second knot).
10.1
Cause:
Insufficient tension on the knotter tongue.
Remedy:
Increase the tension on the knotter tongue (1) (cf.
malfunction no. 9 picture BPXC0267).
10.2
Cause:
Incorrect twine tension.
Remedy:
• Check the twine path To make the knot ends
longer, the lower twine tension should generally be
increased first (cf. malfunction no. 2 picture
BPXC0254).
• In case this is not enough the upper twine tension
must be increased
11 Twine is no longer threaded through the
knotter needle, but it is tied to the last bale.
11.1
Cause:
Twine tension spring is bent
Remedy:
Align the twine spring (1) centrically to the twine brake
(2) and the knotter needle (3).
Pos: 46.37 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_ 0.doc @ 4165
To Next Page
