Krone Big Pack 890 - Page 349

349
Roller crop guide ............................................... 200
S
Safety .................................................................. 34
Safety Instructions and Accident Prevention
Regulations ..................................................... 36
Safety Instructions on the Machine .................... 40
Safety-conscious work practices ........................ 35
Secure knotter shaft .......................................... 222
Setting of blade lever (single knotter) ............... 246
Setting of twine retainer ............................ 244, 248
Setting packer to baling ram ............................. 253
Setting the bale chute ....................................... 261
Setting the bale length (only for electrical bale
length setting) ............................................... 149
Setting the bale length (only with electr. bale
length setting) ................................................. 90
Setting the baling ram blades ........................... 251
Setting the blade lever (double knotter) ............ 250
Setting the coupling (in zero position) .............. 257
Setting the flywheel cleaning (only on BiG PACK
890) ............................................................... 260
Setting the height of the needles on the knotter
...................................................................... 230
Setting the holding force of the twine retainer .. 249
Setting the holding force of the twine retainer (6)
...................................................................... 245
Setting the knotter shaft brake .......................... 238
Setting the MultiBale ......................................... 262
Setting the needle yoke brake .......................... 232
Setting the needles ........................................... 229
Setting the number of MultiBales (MultiBale only)
................................................................ 91, 150
Setting the packer ............................................. 253
Setting the spring of the chain tensioner on the
Pick-up .......................................................... 265
Setting the spring of the zero adjuster .............. 259
Setting the target bale channel flap pressure .... 89,
148
Setting the Transfer Mechanism ....................... 291
Setting the triggering sensitivity ........................ 258
Setting the twine bar (double knotter) ............... 236
Setting the twine bar (single knotter) ................ 235
Setting the twine tension of the lower twine strand
(double knotter) ............................................ 241
Setting the twine tension on the upper twine
strand (double knotter) ................................. 240
Setting the upper needle .................................. 234
Setting the zero position .................................. 257
Settings ............................................................ 221
Single knotter ........................... 223, 239, 243, 325
Spare Parts ...................................................... 267
Start-up .............................................................. 58
Supports for compressed air
hoses ................... 67
Switching the terminal on / off when the machine
is connected ................................................. 143
Switching the terminal on / off when the machine
is not connected ........................................... 142
Swivelling parking support into transport position
....................................................................... 50
T
Technical data .................................................... 17
Threading the twine ......................................... 226
Tightening Torques .......................................... 269
Tightening Torques (Countersunk Screws) ..... 270
To apply the parking brake ................................ 74
Top dead centre of the needles ....................... 231
Transfer gearbox .............................................. 285
Troubleshooting in the central lubrication ........ 339
Twine ............................................................... 212
Twine bar ......................................................... 235
Twine brake ..................................................... 239
Twine motion indicator upper twine (double
knotter) ......................................................... 213
Tying unit ......................................................... 222
Tyres .......................................................... 39, 271
U
Unauthorised Conversion/Modification and Spare
Parts Production ............................................ 40
Unlocking the blade shaft ................................ 205
Upper twine ...................................................... 228
V
Variable filling system (VFS) ............................ 256