Krone Comprima V 180 - Menu 1 Number of Film Layers (Chamber Film Wrapping); Menu 3 Advance Signalling

Terminal menus 13
Menu 1 “Number of film layers” (chamber film wrapping) 13.9
Comprima V 180
Original Operating Instructions 150001053_00_en 119
13.9 Menu 1 “Number of film layers” (chamber film wrapping)
5,0
1,5
3.5
n
1
n
+
-
EQG003-001
ü For The menu level is active, refer to page114.
ü Chamber film wrapping is selected in menu 8 “Type of tying”, refer to page122.
 To open the menu, press
n
.
Æ The display shows menu "Number of film layers".
Adjusting the number of film layers
 Increase or decrease the value, refer to page115.
 To save the value, press .
INFORMATION
KRONE recommends 3.5 – 4 film layers for optimum chamber film wrapping. The minimum
required film layers depend on the condition of the crops.
With round bales whose diameter measures more than 130cm and/or very dry or very wet
crops, KRONE recommends at least one additional film layer.
13.10 Menu 3 “Advance signalling”
Pre-signalling is used to warn if the round bale in the bale chamber is near completion. On the
terminal you can set the filling for which pre-signalling starts.