Krone Comprima V 180 - Checking the Screw Connections on the Drawbar; Setting the Scraper and Stone Deflector; Setting the Scraper to the Spiral Roller

Maintenance 16
Checking the screw connections on the drawbar 16.12
Comprima V 180
Original Operating Instructions 150001053_00_en 177
16.12 Checking the screw connections on the drawbar
1
2
RPG000-088
 Check whether the screw connections(1) or(2) were tightened to the correct tightening
torque.
 Tighten the screw connections(1) on the drawbar to the tightening torque 210Nm.
 Tighten the screw connections(2) on the drawbar eye to the tightening torque 730Nm.
Maintenance interval, refer to page160.
16.13 Setting the scraper and stone deflector
16.13.1 Setting the scraper to the spiral roller
For the "Net and chamber film wrapping" version
The following information label is affixed to the machine:
27 018 237 0
1
2
RP000-301
 Ensure that the scraper(2) is very close to the spiral roller(1).
 If the scraper(2) is not very close to the spiral roller(1), set the scraper(2) as described
below.
ü The tailgate is open and the tailgate is hydraulically locked, refer to page73.
ü The side guard on the right side of the machine side is open.