Krone Comprima V 180 - Carrying out Oil Level Check and Oil and Filter Element Changes Safely; Running Actuator Test

2 Safety
2.5 Safety routines
26
Comprima V 180
Original Operating Instructions 150001053_00_en
In order to safely support the machine or machine parts:
 To support, only use suitable and sufficiently dimensioned materials that do not break or
yield.
 Bricks and hollow blocks are not suitable for safely supporting the machine and machine
parts. Therefore they must not be used.
 Car jacks are also not suitable for safely supporting the machine and machine parts. They
must not be used, as well.
2.5.3 Carrying out oil level check and oil and filter element changes safely
WARNING
Carrying out oil level check and oil and filter element changes safely
If oil level check and oil and filter element changes are not carried out safely, the operational
safety of the machine may be impaired. This may result in accidents.
 Carry out oil level check and oil and filter element changes safely.
To carry out oil level check, oil and filter element changes safely:
 Lower raised machine parts or secure them against falling, refer to page25.
 Shut down and safeguard the machine, refer to page25.
 Observe the intervals for oil level check, oil and filter element changes, refer to page160.
 Use only the oil grades and quantities specified in the consumables table, refer to page41.
 Clean the area around the parts (for example gearbox, high-pressure filter) and make sure
that no foreign objects get into the parts or the hydraulic system.
 Check existing seal rings for damage and replace them, if necessary.
 Collect leaking or waste oil in a container designated for the purpose and dispose of it
properly, refer to page21.
2.5.4 Running actuator test
WARNING
Run actuator test safely
When actuators are energised, functions are carried out directly and without a safety prompt.
This may cause the unintentional movement of machine parts, trapping and seriously or
fatally injuring persons.
ü Only persons familiar with the machine are permitted to perform the actuator test.
ü The person performing the test must know which machine parts are activated by
controlling the actuators.
 Run the actuator test safely.
To run the actuator test safely:
 Lower raised machine parts or secure them against falling, refer to page25.
 Shut down and secure the machine, refer to page25.
 Cordon off the danger zone of the actuated moving machine parts in a clearly visible
manner.