Krone Comprima V 180 - Settings; Setting the Baling Pressure

15 Settings
15.1 Setting the baling pressure
146
Comprima V 180
Original Operating Instructions 150001053_00_en
15 Settings
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
 To avoid accidents, the relevant safety instructions must be read and observed, refer to
page14.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
 The safety routines must be read and observed to avoid accidents, refer to page25.
15.1 Setting the baling pressure
NOTICE
Tampering with the pressure controller will invalidate the guarantee!
1
3
2
RP000-428
The baling pressure is set on the left side of the machine.
The following pressure ranges are recommended by KRONE:
Type of crop Recommended pressure range
Hay low
Straw medium/high
Silage high
The baling pressure can only be adjusted when crops are supplied to the bale chamber. The
maximum baling pressure must not exceed 180bar. When opening the tailgate, the pressure
indicated on the pressure gauge(3) must not exceed 210bar. The minimum pressure must not
fall below 50bar.
 Screw in the handwheels(1) and(2) anti-clockwise all the way.
 Pick up crops with the machine until the pressure gauge(3) indicates the baling pressure
which is at least 10bar above the required baling pressure.
 To increase the baling pressure, turn the handwheel(2) clockwise.
 To reduce the baling pressure, turn the handwheel(2) anti-clockwise.