Krone Comprima V 180 - Menu 4 Tying Start Delay (Chamber Film Wrapping); Menu 6 Electronic Baling Pressure Adjustment

Terminal menus 13
Menu 4 “Tying start delay” (chamber film wrapping) 13.12
Comprima V 180
Original Operating Instructions 150001053_00_en 121
Adjusting the tying start delay
 Increase or decrease the value, refer to page115.
 To save the value, press .
13.12 Menu 4 “Tying start delay” (chamber film wrapping)
Tying start delay is used to set the period of time which is required between completion of round
bale in the bale chamber and triggering the tying cycle. The tying start delay is set in seconds.
Setting range: 0.0–2.5s
n
+
-
2,5
0,0
0.0
s
4
EQG003-004
ü For The menu level is active, refer to page114.
ü Chamber film wrapping is selected in menu 8 “Type of tying”, refer to page122.
 To open the menu, press .
Æ The display shows menu “Tying start delay”.
Special feature of chamber film wrapping
The tying start delay is automatically set to 0.0 s for chamber film wrapping. KRONE
recommends this setting.
At high driving speeds, the tying start delay can be set to a minimum for chamber film wrapping:
 Increase or decrease the value, refer to page115.
 To save the value, press .
13.13 Menu 6 "Electronic baling pressure adjustment"
NOTICE
Damage to the machine due to baling pressure set too low or too high
The machine may be damaged if the baling pressure is above 190bar or below 50bar.
 Do not operate the machine if the baling pressure is too low or too high.
 Select and set a baling pressure between 50 and 190bar, refer to page146.