Krone Comprima V 180 - Menu 15-3 Software Info

13 Terminal menus
13.20 Menu 15 "Settings"
140
Comprima V 180
Original Operating Instructions 150001053_00_en
Diagnostics of actuator for wrapping process
2
state:
15-2
Q30
M01
M1
EQG000-053
The actuator for wrapping process M01 can be tested by moving it into the feed or cutting
position.
 To move the actuator for wrapping process into the feed position, press .
 To move the actuator for wrapping process into the cutting position, press .
13.20.3 Menu 15-3 "Software info"
KRONE
SW: D2515020105400000 0B0
15-3
EQG000-016
ü Menu 15 “Settings” is called, refer to page132.
 To open the menu, press .
Æ The display shows the "Software info" menu.
Display area
Icon Designation
SW Total software version of the machine