Initial operation 6
Mounting hose and cable support 6.2
Comprima V 180
Original Operating Instructions 150001053_00_en 45
6.2 Mounting hose and cable support
RPG000-010
ü The machine is shut down and safeguarded, refer to page25.
Remove the hose and cable support (1) from the storage compartment.
Insert the hose and cable support (1) into the oblong holes (3) on the right-hand and left-
hand side of the drawbar.
Mount the hose and cable support (1) with the terminals (2) from the inside and with the nuts
(4) from the outside.
Æ The hoses and cables can be guided through the eye on the hose and cable support (1)
towards the tractor.
6.3 Preparing the brake disc of the wrapping material brake
RPG000-011
Remove the duct tape (1) provided as corrosion protection from the surface of the brake
disc (2) and discard.
6.4 Checking/adapting the tyre pressure
Before the initial operation, check and adjust the tyre pressure. A label at the PTO shaft end
draws the attention to this important test:
To Next Page
Loading...
