Machine description 4
Function description of the bale formation conveyor stop 4.6
Comprima V 180
Original Operating Instructions 150001053_00_en 39
When tying is started, the feed rocker arm(15) guides the wrapping material (net or film) via the
feed unit(12) onto the feed roller(11). The feed roller(11) guides the wrapping material (net or
film) between the compression rollers(10) to the round bale and pulls it off the round bale.
When the tying cycle of the set number of net or film layers is complete, the cutting unit(10)
swings over the wrapping material (net or film) and cuts the wrapping material (net or film).
4.6 Function description of the bale formation conveyor stop
For "Bale formation conveyor stop" version
The bale formation conveyor stop is used to switch off the bale formation conveyor when
opening the tailgate. On extreme slopes, depositing of the bale can be prevented by the
tailgate.
When the tailgate is opened, the coupling is automatically actuated via an actuating lever and
the wire rope and the bale formation conveyor is switched off.
To Next Page
Loading...
