Krone Comprima V 180 - Maintenance - Once after 10 Hours; Maintenance - Once after 50 Hours; Maintenance - Once after 500 Round Bales; Maintenance - Every 50 Hours

Maintenance 16
Maintenance table 16.1
Comprima V 180
Original Operating Instructions 150001053_00_en 161
16.1.2 Maintenance – once after 10 hours
Components
Retighten wheel nuts refer to page172
Tighten the screw connections on the drawbar refer to page177
Check tyre pressure refer to page172
Have the slack adjuster of the brake system
checked by KRONE service partners
Check the hydraulic hoses for leaks and, if ne-
cessary, have them replaced by a KRONE
service partner.
Clean the bushing and the drawbar eye refer to page176
Check rear bale formation conveyor and ad-
just if required
refer to page185
16.1.3 Maintenance – once after 50 hours
Changing oil
Main gearbox refer to page173
16.1.4 Maintenance – Once after 500 round bales
Components
16.1.5 Maintenance – every 10 hours, at least daily
Checking oil level
Main gearbox refer to page173
Components
Clean the machine refer to page174
Check that the brake system functions
Clean the bushing and the drawbar eye refer to page176
Check dosing units of the central chain lubric-
ation system and clean if required
refer to page189
16.1.6 Maintenance – every 50 hours
Components
Tighten screws/nuts on the machine refer to page166
Tighten the screw connections on the drawbar refer to page177
Retighten wheel nuts refer to page172
Check tyre pressure refer to page172
Drain condensation water out of the com-
pressed air tank
refer to page191