Krone Comprima V 180 - Faults of the Electrics;Electronics; Error Messages

17 Malfunction, cause and remedy
17.5 Faults of the electrics/electronics
200
Comprima V 180
Original Operating Instructions 150001053_00_en
17.5 Faults of the electrics/electronics
17.5.1 Error Messages
WARNING
Personal injuries and/or machine damage caused by non-compliance of error
messages
If error messages are ignored and the malfunction is not remedied, people may be injured
and/or the machine may be damaged seriously.
 Remedy the malfunction when the error message is displayed, refer to page202.
 If the malfunction cannot be remedied, contact KRONE Customer Service.
KMC - 521202- 5
B11
L
EQG000-034
The display shows an error message if a malfunction occurs on the machine. At the same time,
an audio signal will be heard (continuous horn sound). Description of malfunction, possible
cause and remedy, refer to page202.
Configuration of an error message
The error message is configured according to the following sample: e.g. error message
"520192-19
KBT
"
520192 19
KBT
SPN (Suspect Parameter
Number) = error number
FMI=type of error, refer to
page201
Icon
Acknowledging the error message
 Note down the error message.
 Briefly press .
Æ The acoustic signal stops and the error display disappears.
 Eliminate the error, refer to page202.
If the fault occurs again, the error message will appear again.
Acknowledge and still pending error messages can be displayed again via the status line, refer
to page102.