Krone Comprima V 180 - Maintenance; Maintenance Table; Maintenance - Prior to the Beginning of the Season

16 Maintenance
16.1 Maintenance table
160
Comprima V 180
Original Operating Instructions 150001053_00_en
16 Maintenance
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
 To avoid accidents, the relevant safety instructions must be read and observed, refer to
page14.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
 The safety routines must be read and observed to avoid accidents, refer to page25.
16.1 Maintenance table
16.1.1 Maintenance – prior to the beginning of the season
Checking oil level
Main gearbox refer to page173
Central chain lubrication system refer to page188
Components
Adjust drive chains refer to page181
Tighten screws/nuts on the machine refer to page166
Retighten wheel nuts refer to page172
Check tyre pressure refer to page172
Vent friction clutch refer to page180
Clean the bushing and the drawbar eye refer to page176
Change filter on the central chain lubrication
system
refer to page189
Drain condensation water out of the com-
pressed air tank
refer to page191
Prepare brake disc of the wrapping material
brake
refer to page45
Grease lubrication points according to lubrica-
tion chart
refer to page162
Actuate tying cycle and check functions refer to page69
Check the hydraulic hoses for leaks and, if ne-
cessary, have them replaced by a KRONE
service partner.
Cleaning deflection pipes or conical tying roller refer to page174
Check electrical connection cables and road
travel lighting
refer to page143