Krone Comprima V 180 - Consumables

Technical data 5
Consumables 5.1
Comprima V 180
Original Operating Instructions 150001053_00_en 41
Electrical connections
Electr. connection for road travel lighting (7-pole plug) 12 volts
Electr. connection for operation (3-pole plug) ----
Necessary hydraulic connections at the tractor
Hydraulic connection (T)/depressurized return in the tank 1 x
Single-acting hydraulic connection 2 x
For version with "Hydraulic support jack"
Double-acting hydraulic connection
1 x
Tyre designation Minimum pres-
sure
V
max
=10km/h
Maximum pres-
sure
Recommended tyre pressure
1
Single axle Tandem axle
Guide wheels on the pick-up
15x6.00-6 3.2 bar
Tyres on the machine
15.0/55-17 1.3 bar 3.6 bar 2.6 bar 1.5 bar
500/50-17 1.0 bar 2.8 bar 2.0 bar 1.5 bar
500/55-20 1.0 bar 3.0 bar 1.5 bar 1.5 bar
1
This recommendation applies especially to the typical mixture of operation (field/road) at the
maximum permitted machine speed. If required, the tyre pressure can be reduced to the
indicated minimum air pressure. However, the associated maximum speed must then be
observed.
Ambient temperature
Temperature range for machine operation -5 to +45°C
5.1 Consumables
NOTICE
Complying with change intervals for biooils
To ensure high life expectancy of the machine, it is absolutely necessary to comply with
change intervals for biooils due to the ageing of the oils.
NOTICE
Mixing types of oil
If types of oil are mixed, the machine could be damaged.
 Never mix different types of oil.
 Before changing the type of oil, consult customer service. Never use engine oil.
Biodegradable consumables can be used on request.