Krone Comprima V 180 - Operation; Preparation before Baling; Filling the Bale Chamber

8 Operation
8.1 Preparation before baling
66
Comprima V 180
Original Operating Instructions 150001053_00_en
8 Operation
WARNING
Risk of injury due to non-observance of relevant safety instructions
If the relevant safety instructions are not observed, persons may be seriously injured or killed.
 To avoid accidents, the relevant safety instructions must be read and observed, refer to
page14.
WARNING
Risk of injury due to non-observance of safety instructions
If the relevant safety routines are not observed, persons may be seriously injured or killed.
 The safety routines must be read and observed to avoid accidents, refer to page25.
WARNING
Risk of injury due to unpredictable movement of the round bales when the machine is
operating on a slope
If round bales are deposited on a slope, they may start moving on their own. Once round
bales have started moving, their weight and cylindrical shape may cause serious accidents
and injure people.
 On slopes, deposit round bales in manual mode only.
 On slopes, always deposit round bales in such a way that they cannot start moving on
their own.
8.1 Preparation before baling
ü The bale formation conveyor is in working position, refer to page69.
ü The pick-up is in working position, refer to page75.
ü The crop press roller unit has been correctly set according to the amount of crops, refer to
page78.
ü The wrapping material has been correctly inserted.
Net wrapping: refer to page80
Chamber film wrapping: refer to page82
ü The baling pressure has been set.
Without terminal: refer to page146, with terminal for version with "Electronic baling pressure
adjustment": refer to page122.
ü The customer counter has been set to 0, refer to page126.
8.2 Filling the bale chamber
NOTICE
Machine damage due to machine overload
If round bales are too firm or too large, the machine may be damaged and the service life
considerably reduced. In the event of an overload, forced tying is automatically actuated
which is saved on the terminal.
 Press only round bales which do not exceed the set baling pressure and bale diameter.
 Observe the following information on the even filling of the bale chamber.