Krone Comprima V 180 - Page 219

Malfunction, cause and remedy 17
Faults of the electrics/electronics 17.5
Comprima V 180
Original Operating Instructions 150001053_00_en 219
Possible cause Remedy
FMI 2: The tailgate is open while starting up the machine.
The tailgate is not locked.
 Close the tailgate using the tractor hydraulics.
The sensor is defective or has
been incorrectly set.
 Check and set the sensorsB11/B12 “Lock hook bale
chamber left/Lock hook bale chamber right”, refer to
page133.
522048-
Tailgate
Possible cause Remedy
FMI 2: – The tailgate is open during road operating mode.
The tailgate is not locked.
 Close the tailgate using the tractor hydraulics.
The sensor is defective or has
been incorrectly set.
 Check and set the sensorsB11/B12 “Lock hook bale
chamber left/Lock hook bale chamber right”, refer to
page202.
522049-
Tailgate
Possible cause Remedy
FMI 2:An open tailgate was detected, although no tying has occurred since it was last closed.

The baling pressure is too
high.
 Start net or chamber film wrapping in manual mode and tie
the round bale.
For "Net wrapping" version: refer to page124
For "Net and chamber film wrapping" version: refer to
page125
The bale chamber is overfilled
so that it was opened by the
bale.
 Manually empty the bale chamber.
The tailgate is not correctly
locked.
 Open and close the tailgate again.
522101-
B01
SensorB01 “Speed of bale chamber”
Possible cause Remedy
FMI 4: An undervoltage or a short circuit to ground has occurred.
FMI 5: A cable break has occurred or the current intensity is too weak.
The sensor shows external
damage.
 Check sensor and wiring for damage, refer to page202.
The wiring of the sensor is de-
fective.
522102-
B02
SensorB02 "Tying process active"