2-23
Installing and Setting up the Machine > Energy Saver function
Sleep
Select the [Energy Saver] key. Touch panel and all indicators on the operation panel will go out to save a maximum
amount of power except the Energy Saver indicator. This status is referred to as Sleep.
If print data is received during Sleep, the machine automatically wakes up and starts printing. Also when fax data arrives
while the machine is in Sleep, the machine automatically wakes up and starts printing.
To resume, perform the following actions.
• Press any key on the operation panel.
• Touch the touch panel.
• Place originals in the document processor.
The machine will be ready to operate within the following time.
• ECOSYS M8124cidn: within 15.1 seconds
• ECOSYS M8130cidn: within 17.6 seconds
Note that ambient environmental conditions, such as ventilation, may cause the machine to respond more slowly.
Auto Sleep
Auto Sleep automatically switches the machine into Sleep if left idle for a preset time.
The default preset time is 15 minutes.
To change the preset sleep time, refer to the following:
Quick Setup Wizard (2-25)
Sleep Rules (models for Europe)
You can set whether sleep mode operates for each function. When the machine enters sleep mode, the ID card cannot
be recognized.
For more information on Sleep Rules settings, refer to the following:
Quick Setup Wizard (2-25)
To Next Page
Loading...
Need help?
General
