Kyocera Ecosys M812cidn

8-42
System Menu > [System/Network]
[Protocol Settings]
Menu Transition: [System Menu/Counter] key > [System/Network] > [Network] > [Protocol Settings]
Configure the protocol settings.
Item Description
NetBEUI ―
Protocol Settings Selects whether to receive documents using NetBEUI.
*1
Value: Off, On
Available Network
(Wi-FiDirect)
Select whether or not each network is enabled.
Value: Disable, Enable
NOTE
This setting is displayed when the [Protocol Settings] setting is [On].
Available Network
(Wi-Fi)
Available Network
(Wired Network)
LPD ―
Protocol Settings Selects whether to receive documents using LPD.
*1
Value: Off, On
Available Network
(Wi-Fi Direct)
Select whether or not each network is enabled.
Value: Disable, Enable
NOTE
This setting is displayed when the [Protocol Settings] setting is [On].
Available Network
(Wi-Fi)
Available Network
(Wired Network)
SMTP (E-mail TX) Select whether to send E-mail using SMTP.
Value: Off, On
POP3 (E-mail RX) Select whether to receive E-mail using POP3.
Value: Off, On
FTP Client (Transmission) Select whether to send documents using FTP. To use the Thin Print protocol, set the
protocol to [On]. The default port number is 21.
Value: Off, On
FTP Server (Reception) ―
Protocol Settings Select whether to receive documents using FTP.
*1
Value: Off, On
Available Network
(Wi-FiDirect)
Select whether or not each network is enabled.
Value: Disable, Enable
NOTE
This setting is displayed when the [Protocol Settings] setting is [On].
Available Network
(Wi-Fi)
Available Network
(Wired Network)
SMB Client
(Transmission):
Select whether to send documents using SMB. To use SMB, select [On] for this setting. The
default port number is 445.
Value: Off, On