5-4
Operation on the Machine > Place the Originals.
When you place envelopes or cardstock on the platen
Loading Originals in the Document Processor
The document processor automatically scans each sheet of multiple originals. Both sides of two-sided originals are
scanned.
Originals Supported by the Document Processor
Do not use the document processor for the following types of originals. Otherwise, the originals may be jammed or the
document processor may become dirty.
• Document Processor Originals Not Supported by the Document Processor Originals bound with clips or staples
(Remove the clips or staples and straighten curls, wrinkles or creases before loading. Failure to do so may cause the
originals to jam.)
• Originals with adhesive tape or glue
• Originals with cut-out sections
1 Put the
scanning side
facedown.
2 Align it flush
against the
original size
indicator plates
with the back
left corner as
the reference
point.
• For the procedure for feeding envelopes or cardstock, refer to the following:
When you place envelopes or cardstock on the platen (5-9)
Do not leave the document processor open as there is a danger of personal injury.
• Do not push the document processor forcefully when you close it. Excessive pressure may crack the
platen glass.
• When placing books or magazines on the machine, do so with the document processor in the open
position.
Weight 45 to 160 g/m
2
(duplex: 50 to 120 g/m
2
)
Sizes Maximum A3/Ledger (297 x 432 mm) (Long-sized 297 x 1,900 mm) to Minimum A5-R/
Statement-R (140 x 182 mm)
No. of sheets Plain paper (80 g/m
2
), Color paper, Recycled paper, High Quality paper: 50 sheets
To Next Page
Loading...
Need help?
General
