Kyocera Ecosys M812cidn - Executing Favorites in Wizard Mode

3-44
Preparation before Use > Recalling Frequently Used Functions (Favorites)
5 Check the content. Change or add information as needed.
*1 If user login administration is enabled, you can only change settings by logging in with administrator privileges.
*2 Displayed when user login administration is enabled.
6 Select [Register].
This adds the favorite.
7 "Do you want to add a new function to the home screen?" screen appears. To display a favorite to the Home
screen, select [Yes], specify the location where you want to display the icon of the favorite, and then select
[Save].
Executing Favorites in Wizard Mode
The procedure for recalling and executing a favorite in Wizard Mode is shown below.
1
Recalling the favorite.
1 On the Home screen, select [Favorites] or select the key of a favorite.
If you selected the key of a favorite, that favorite will be recalled. If you selected [Favorites], proceed with the following
steps.
2 Select the key of the favorite you want to recall.
2
This executes the favorite.
1 A series of screens will appear, so configure settings and then select [Next >].
The Transmit Settings dialog box will appear.
2 Place the originals > [Start] key
Item Description
Name Enter up to 32 characters for the name that appears on the Favorites screen.
Add - Job Type Shows the type of the selected job.
Number
*1
Enter a number for the favorite.
If you specify "00" as the address number, the address is added under the lowest available
number.
Owner
*2
Shows the user.
Permission
*2
Specifies whether favorites should be shared with other users.
Function Format Selects the method used to recall favorites.
NOTE
To change a setting, select [< Back] and then make the changes you want.