Kyocera Ecosys M812cidn User Manual

2-48
Installing and Setting up the Machine > Command Center RX
4
Configure the Settings.
Enter "SMTP" and "E-mail Send Settings" items.
5
Click [Submit].
Description Description
SMTP Set to send e-mail from the machine.
SMTP Protocol Displays the SMTP protocol settings. Check that "SMTP Protocol" is set
to [On]. If [Off] is set, click [Protocol] and set the SMTP protocol to [On].
SMTP Server Name
*1
Enter the host name or IP address of the SMTP server.
SMTP Port Number Specify the port number to be used for SMTP. The default port number
is 25.
SMTP Server Timeout Enter the timeout period in seconds.
Authentication Protocol To use SMTP authentication, enter the user information for
authentication.
SMTP
Security
Set SMTP security.
Turn on "SMTP Security" in "SMTP (E-mail TX)" on the "Protocol
Settings" page.
Connection Test Tests to confirm that the settings are correct without sending the e-mail.
Domain Restriction To restrict the domains, click the [Domain List] and enter the domain
names of addresses to be allowed or rejected. Restriction can also be
specified by e-mail address.
POP3 POP3 Protocol You don't need to set the following items when you only enable the
function of sending e-mail from the machine. Set the following items if
you want to enable the function of receiving e-mail on the machine.
Command Center RX User Guide
Check Interval
Run once now
Domain Restriction
POP3 User Settings
E-mail
Send
Settings
E-mail Size Limit Enter the maximum size, in Kilobytes, of E-mail that can be sent. When
E-mail size is greater than this value, an error message appears and E-
mail sending is cancelled. Use this setting if you have set E-mail Size
Limit for SMTP server. If not, enter a value of 0 (zero) to enable E-mail
sending regardless of the size limit. Entering 0 (zero) sends the E-mail,
regardless of the size limitation.
Sender Address
*1
Specify the sender address for when the machine sends E-mails.
Specify the e-mail address such as an address of the machine
administrator, so that a reply or non-delivery report will go to a person
rather than to the machine. The sender address must be entered
correctly for SMTP authentication.
Sender address: Up to 128 characters
Signature Enter the signature. The signature is free form text that will appear at the
end of the E-mail body. It is often used for further identification of the
machine.
Signature: Up to 512 characters
Function Defaults Change the function default settings in [Common/Job Default Settings]
page.

Kyocera Ecosys M812cidn Specifications

General

Brand	Kyocera
Model	Ecosys M812cidn
Category	All in One Printer
Language	English