11-31
Troubleshooting > Adjustment/Maintenance
1
Load paper.
2
Display the screen.
1 [System Menu / Counter] key > [Adjustment/Maintenance] > [Tone Curve Adjustment]
2 Select [Copy/Print (600dpi)] or [Print (1200dpi)].
3
Perform adjustment.
[Copy/Print (600dpi)]
3 pattern pages (No. 1 to 3) are printed out.
1 Select [Start].
Check that the number "1" is printed at the bottom of the pattern.
2 As shown in the illustration, place the printed side down on the platen with the edge with the arrows toward the
back and close the original holder.
• Load the paper with the print side facing up.
• After removing new paper from its packaging, fan the paper before loading it in the multi-purpose tray.
Precaution for Loading Paper (3-17)
• Before loading the paper, be sure that it is not curled or folded. Paper that is curled or folded may
cause paper jams.
• Ensure that the loaded paper does not exceed the level indicator.
• If paper is loaded without adjusting the paper length guide and paper width guide, the paper may
skew or become jammed.
To Next Page
Loading...
