Lenze i510 - Installation; Mechanical Installation; Electrical Installation

4.4.1 General notes on parameters
Each parameter features a 16-bit index as address. Under this address, the parameter is
stored in the object direct
ory of the inverter.
•
Parameter
s that belong together funconally are combined in a data set. These parameters
are addionally provided with an 8-bit subindex.
•
In the
documentaon the colon is used as a separator between the index and subindex.
Example: "0x2540:001"
•
There are parameters the seng of which can be changed, and (diagnosc) parameters
which can only be read.
Parameterisaon using the keypad
•
All parameters which c
an be accessed by means of the keypad are provided with a "Display
code", the rst digit of the display code specifying the group in which the parameter can be
found on the keypad.
•
In the documentaon, the displa
y code — if available — is specied in brackets behind the
address. Example: "0x2915 (PAR 210)".
•
Parameters belonging together funconally and being provided with a subindex on the key-
pad are shown in the SUB parameter level. In the documentaon, the diagonal slash "/" is
used as a separator between the display code (PAR) and the subindex (SUB). Example:
"PAR 208/001"
Structure of the parameter descripons in this documentaon
•
The parameter descripons in this documentaon are s
tructured in table form.
•
The representaon disnguishes parameter
s with a seng range, text, selecon list, and
bit-coded display.
•
The default seng of parameters with a write access feature is shown in bold.
•
The display code as well as the abbreviated keypad designaon of the parameter, which is
limited to 16 characters, are shown in italics.
Example: parameters with a seng range
Parameter Name / value range / [default seng] Info
Index:Subindex
(display code)
Paramet
er designaon
(abbreviated keypad designaon)
Minimum value ... [default seng ] ... maximum value
•
Oponal informaon with regard to the parameter.
Explanaons & notes with regard to the parameter.
Example: parameters with a selecon list
Parameter Name / value range / [default seng] Info
Index:Subindex
(display code)
Paramet
er designaon
(abbreviated keypad designaon)
•
Oponal informaon with regard to the parameter.
Explanaons & notes with regard to the parameter.
Note: The corresponding selecon number (here 0, 1, or 2) must be set.
Other values are not permissible.
0 Designaon of selecon 0 Oponally: Explanaons & notes with regard to the corresponding selec-
on.
The default selecon is shown in bold.
1 Designaon of selecon 1
2 Designaon of selecon 2
Example: parameters with a bit-coded display
Parameter Name / value range / [default seng] Info
Index:Subindex
(display code)
Paramet
er designaon
(abbreviated keypad designaon)
•
Oponal informaon with regard to the parameter.
Explanaons & notes with regard to the parameter.
Bit 0 Designaon of bit 0 Oponally: Explanaons & notes with regard to the corresponding bit.
Bit 1 Designaon of bit 1
Bit 2 Designaon of bit 2
... ...
Bit 15 Designaon of bit 15
Commissioning
Parameter seng
Gener
al notes on parameters
17
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com