Lenze i510 - Keypad Parameter List

4.5 Keypad parameter list
For commissioning or diagnoscs using the keypad, all parameters of the inverter that can
also be accessed by means of the keypad are lis
ted in the following "Keypad parameter list".
•
The keypad paramet
er list is sorted in ascending order in compliance with the "Display
code" (PAR xxx).
•
In order to provide for quick access, all parameters of the inverter are divided into dierent
groups according to their funcon.
•
Group 0 contains the congurable "Favorites". In the default seng these are the most
common parameter
s for the soluon of typical applicaons. 4Favorites ^ 162
•
By the hundreds digit of the PAR number (PAR Xxx) you can quickly see in which group the
parameter is to be found on the keypad:
Group/name Parameter Descripon
Group 1 - Diagnoscs PAR 1xx Diagnosc/display parameters for displaying device-internal process fac-
tors, current actual v
alues, and status messages.
4Diagnoscs ^ 44
Group 2 - basic seng PAR 2
xx Seng of the mains voltage, selecon of the control and setpoint
source, starng and stopping performance, frequency limits and ramp
mes.
4Basic seng ^ 66
Group 3 - Motor Control PAR 3xx Conguraon of the motor and motor control
4Mot
or c
on
tr
ol
^ 77
Group 4 - I/O seng PAR 4xx Funcon assignment and conguraon of the inputs and outputs
4Flexible I/O conguraon ^ 186
Group 5 - netw
ork
seng P
AR 5
xx Conguraon of the ne
tw
ork (if available)
4Conguring the network ^
96
Group 6 - Process Controller PAR 6xx Conguraon of the process controller
4Conguring the process contr
oller ^ 138
Group 7 - Addional Funcons PAR 7xx Parameterisable addional funcons
4
Addional
funcons
^
144
A complete overview of all parameter indexes can be found in the annex in the
Parameter aribute lis
t. ^ 229
How to read the keypad parameter list:
Column Meaning
PAR Parameter number on the keypad
Name / SUB xxx: name Parameter name on the keypad
For SUB parameters: subindex and name
Default seng Default seng of the parameter
Seng range Possible seng range for the parameter. Format: minimum value ... maximum value [unit]
Address Address of the parameter in the object directory. Format: index[:subindex]
Keypad parameter list (short overview of all parameters with display code)
PAR Name / SUB xxx: Name Default seng Seng range Address
PAR 100 Actual frequency x.x Hz - (Read only) 0x2DDD
PAR 101 Scaled actual value x Units - (Read only) 0x400D
PAR 102 Freq. setp. Hz x.x Hz - (Read only) 0x2B0E
PAR 103 Motor current % x.x % - (Read only) 0x6078
PAR 104 Act. motor current x.x A - (Read only) 0x2D88
PAR 105 DC bus x V - (Read only) 0x2D87
PAR 106 Motor voltage x VAC - (Read only) 0x2D89
PAR 107 Actual torque % x.x % - (Read only) 0x6077
* Default seng depending on the size. Firmware-Version 01.01.01.00
Commissioning
Keypad paramet
er list
24
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com