Lenze i510 - Keypad Setpoint Default Setting

Parameter Name / value range / [default seng] Info
2 Analog input 1 The setpoint is specied analogously via X3/AI1.
4Analog input 1 ^ 211
3 Analog input 2 The setpoint is specied analogously via X3/AI2.
4Analog input 2 ^ 213
5 Network The setpoint is specied via network.
Conguring the network ^
96
11
Pr
ocess c
on
troller preset val. 1 For the setpoint selecon, preset values can be parameterised and selec-
ted.
4Setpoint source of preset setpoints ^ 195
12 Process controller preset val. 2
13 Process controller preset val. 3
14 Process controller preset val. 4
15 Process controller preset val. 5
16 Process controller preset val. 6
17 Process controller preset val. 7
18 Process controller preset val. 8
50 Motor potenometer The setpoint is generated by the "Motor potenometer" funcon.
4Motor potenometer setpoin
t sour
ce
^ 198
0x2860:003
(PAR 201/003)
Standard setpoint sources: Torque setpoint source
(Standard setpoint: Torque setp.)
Selecon of the standard setpoint source for torque mode.
•
The standard setpoint source is always acve in torque mode if no
setpoint change-over to another setpoint source via corresponding
triggers/funcons is acve.
1 Keypad The setpoint is specied locally by the keypad.
•
Use the and navigaon keys to change the keypad setpoint
(also during running operaon).
2 Analog input 1 The setpoint is specied analogously via X3/AI1.
4Analog input 1 ^ 211
3 Analog input 2 The setpoint is specied analogously via X3/AI2.
4Analog input 2 ^ 213
50 Motor potenometer The setpoint is generated by the "Motor potenometer"
funcon.
4Mot
or potenometer se
tpoint source
^ 198
6.3.1 Keypad setpoint default seng
For the manual setpoint selecon via keypad the following default sengs are used.
Parameter Name / value range / [default seng] Info
0x2601:001
(PAR 202/001)
Keypad setpoin
ts: Frequency setpoint
(Keypad setpoints: KP freq. setp.)
0.0 ... [20.0] ... 599.0 Hz
Default seng of the keypad setpoint for speed mode.
0x2601:002
(PAR 202/002)
Keypad setpoints: Process controller setpoint
(Keypad setpoints: KP PID setp.)
-300.00 ... [0.00] ... 300.00 PUnit
Default seng of the keypad setpoint for process controller mode.
Basic seng
Selecon of setpoint source
Keypad setpoint de
fault seng
71
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.actechdrives.com - Email: info@actechdrives.com